Using the resource

Command Usage:

/stabilisers setup - This will setup stabilisers on the nearest vehicle. You should stand at a right angle to the vehicle, with the vehicle to your left. This allows for the vehicle to be fully supported so firefighters can move in and free the people stuck inside.

/stabilisers remove - This will remove stabilisers setup on the nearest vehicle. The resource is fully synced, meaning other firefighters can remove stabilisers that they didn’t setup.

/spreaders - This will give you spreaders to use, run the command again to remove them. You can then walk up to a vehicle and an on-screen prompt will ask you to press Enter to force open the vehicle door, or press Spacebar to break off the vehicle door.

/fan setup - This will setup an extractor fan in front of you, spawning the prop. After 20 seconds, all smoke and particles in the area will be removed. The duration of this is configurable in the config file.

/fan remove - This will remove a nearby extractor fan. The resource is fully synced, meaning other firefighters can remove fans that they didn’t setup.

Full Features:

Hydraulic Spreaders - These are a powerful piece of tech, allowing firefighters to rescue somebody stuck inside a vehicle in as little time as possible. They can force car doors open and even break them off, enhancing the entire roleplay experience on scene. This features custom sounds when breaking or forcing doors open, which syncs to all players in the area. Vehicle Stabilisers - Rescuing someone from a vehicle can be a challenging experience, especially when the vehicle is sideways or upside down. These vehicle stabilisers can be easily setup, holding the vehicle in place and making a great addition to screenshots. Ventilation Fan - Having full vision on scene is vital, this ventilation fan will allow you to extract any smoke in the area, along with custom sounds. Custom Props - This resource features two custom props to enhance the roleplay experience.